Job Description:

• Clean and put together surfaces
• Mix plaster substances in trough to preferred consistency
• Apply, stage and easy coats of plaster the use of trowels, floats, brushes and spraying device
• Trowel or spray coats of stucco over exteriors of homes to shape weatherproof surfaces
• Finish corners and angles and create ornamental designs in end coat, if required
• Cure freshly plastered surfaces
• Mould and depletion decorative plaster panels, cornices and trim
• Spray acoustic substances or texture end over partitions and ceilings.
• Measure, reduce and match drywall sheets for set up on partitions and ceilings
• Position and stable sheets to metallic or wood studs or joists
• Cut and depletion metallic nook beads to guard outside corners
• Fill joints, nail indentations, holes and cracks with joint compound the use of trowel and wide knife
• Tape over joints the use of taping gadget and embed tape in compound
• Smooth out extra compound and permit coat to dry
• Apply successive coats of compound and sand seams and joints
• Fabricate and depletion suspended metallic ceiling grids and vicinity in panels to shape acoustical and coffered ceilings.
• Prepare wall and ceiling layouts
• Install metallic stud framing and furring for indoors drywall or plaster partitions and ceilings, the use of hand and strength gear
• Attach metallic or gypsum lath to studs or furring the use of nails, screws, clips or cord ties
• Cut openings in lath for heating and air flow piping, ducts and electric shops
• Install nook beads and twine mesh round beams to which plaster is to be implemented
• May depletion acoustic tile, hangers for suspended ceilings and metallic studs for composition wallboard or lath.

Job Requirements:

• Generally a high school diploma is required.
• Completion of a three- or four-year apprenticeship in plastering, drywall or turning
• Usually requires a combination of more than three years of work experience and some high school, college, or industry plastering, plastering or turning.
• Professional drywall installation and finishing certificates are available.
• Professional certification for lathes (furniture mills) is required.
• Red Seal Certification is also offered to qualified lathes (interior systems mechanics) after passing the intercity Red Seal exam.

Terms of Employment:

• Full time
• Permanent
• 40 hours per week
• Day, Evening, Shift, Overtime, Morning